What mounting hole pattern should I expect on my tailgate?

The wing is engineered for standard tailgate mounting geometry. Before drilling, measure your tailgate's existing holes or reinforced zones and compare them to the wing's base plate. Minor drilling may be required depending on your specific setup — use a template or test-fit cardboard first.

Will the wing interfere with my tonneau cover or bed cover?

The Texas Twister profile sits above the tailgate surface. If you run a low-profile tonneau or retractable cover, verify clearance by measuring from the closed tailgate to your cover's height at the rear edge. A gap of at least 2–3 inches is recommended to avoid contact during opening and closing.

What prep work is needed before I apply finish?

Sand the surface lightly to ensure paint adhesion, then clean thoroughly to remove dust. Follow your paint manufacturer's instructions for primer and topcoat application. FRP responds well to standard automotive finishing — no special equipment required beyond standard spray or brush techniques.